1、上線時候不得使用吸、排氣管和儲液器來搬運壓縮機，以避免對壓縮機外觀造成損傷。

　　2、鮮肉柜制冷壓縮機腳墊與壓縮機地腳固定螺母之間必須保證一定的間隙，否則壓縮機本身的振動容易通過地腳螺栓傳遞到底盤引起系統(tǒng)的振動大。該間隙一般要求在0.5~2mm之間;注意安裝過程中不要強行打入固定螺母導致地腳螺栓的彎曲變形。

　　3、裝配過程中時候要注意鮮肉柜制冷壓縮機與配管、管與管之間的距離至少應該有15~20mm，以避免出現(xiàn)碰管現(xiàn)象。

　　4、拔掉鮮肉柜制冷壓縮機的橡皮塞到焊接配管之間的間隔時間最好不超過15分鐘(特別是新冷媒空調，注意換班與工間休息時不要停放未拔掉橡膠塞的壓縮機)，而且要注意此間的工序過程不要存在可能導致有異物落到壓縮機內部的工序(如在壓縮機上方上螺釘?shù)?存在。

　　絕對禁止有任何異物(包括任何固體、液體)從排氣管或者吸氣管進入鮮肉柜制冷壓縮機內部;如果有異物進入壓縮機內部，請不要運行并將該壓縮機封口下線。
 

　　1, when the line is not allowed to use suction, exhaust pipes and liquid accumulator to carry the compressor, so as to avoid damage to the appearance of compressor.

　　2. A certain clearance must be ensured between the feet of the refrigerator compressor and the fixed nut of the compressor. Otherwise the vibration of the compressor itself is easily transmitted to the chassis by the foot bolt to the chassis. The gap is generally between 0.5~2mm. Attention should be paid not to force the nut into the installation process to cause the bending deformation of the anchor bolts.

　　3, during the assembly process, we should pay attention to the distance between the refrigerating compressor and the piping and the pipe between the fresh meat cabinet, at least 15~20mm, so as to avoid the phenomenon of pipe collision.

　　4. The interval between the rubber plug of the refrigerator compressor of the fresh meat cabinet to the welding pipe is best not more than 15 minutes (especially the new refrigerant air conditioner, pay attention to the shift and the interworker rest not to unplug the compressor of the rubber plug), and be aware that the process does not exist in this process that may cause the foreign body to fall inside the compressor. The process (such as the upper screw on the compressor) exists.

　　Absolutely prohibit any foreign objects (including any solid, liquid) from the exhaust pipe or suction pipe into the refrigerator compressor of the fresh meat cabinet; if there are foreign objects entering the compressor, do not run the compressor and seal the compressor off the line.